How To Install Vinyl Siding On Dormers

Place another piece of siding against the angle of the roof where the roof meets the dormer so that the two pieces of siding meet to overlap.

How to install vinyl siding on dormers.

Make the vertical cuts on the siding panel with a saw and make the horizontal cut with a utility knife then snap out the piece. Cut vinyl panels with tin snips to fit along. How to install vinyl siding on dormers step 1. Step 1 vinyl accessories the first thing you will need to do is attach the vinyl j mold to the dormer along the joint between the dormer and the roof.

Install the cut pieces of siding above and below the windows as normal. Many people like this vinyl siding because of its features like it can also be installed on the dormers of the house but you need some tactics to avoid the damage on the dormers. Bob helps carpenter bob ryley apply exterior trim to the gable end dormer window. Take a pencil and draw a line on the horizontal piece of siding that is against the dormer side following the line where the second piece of siding overlaps the first piece.

As vinyl siding is considered to be one of the most authentic sidings from the other because it is inexpensive and easy to install. Level the piece of siding. For insulated siding the. Attach matching vinyl j mold to the angled side of the dormer along the roof line.

Once that is done you can start the siding. Install the trim pieces first. 8 install the top row of siding. Make sure this is a very snug and comfortable fit.

Using the chalkline as a guide install the top edge of the starter strip along the chalkline nailing at 10 254mm. Nail in the center of the starter strip nailing slots. Install corner posts on the two dormer corners utility trim under the window sill and at the tops of the three walls. Use a vinyl corner piece along the front section of the dormer.

Cut this with tin snips so it is about 1 4 inch short. Ryley demonstrates how to avoid seams how to transfer an angle from the roof to the trim and how to create the. Fasten metal starter strip at the bottom of the three walls. Pull the paper out and over the flashing after and use tuck tape to tape it to the flashing.