How To Put Up Cedar Wave Pattern Siding

Start at the bottom of the wall at one end.

How to put up cedar wave pattern siding.

Start a second layer with a partial board so the siding seams do not align. Installing cedar shakes is pretty much the same as installing shingles. Waterproof the window sills by covering them with flex wrap. This is when each piece of cedar siding covers half of the one below it much like staggering and layering on cedar siding on top of one another to provide a scale like appearance.

In horizontal application start at the bottom and work up with the groove edges facing downwards. This will enable you to coat both faces the sides and the top and bottom edges with no trouble. Thick narrow siding is more stable than thinner wider. Begin the installation by wrapping the house with a waterproof membrane either 15 to 30 pound felt or semi permeable house wrap.

The pro s way to install cedar siding. Overlap the bottom of the second board 1 inch over the top of the. Extend the flex wrap at least 6 inches up the sides of each window opening. Use thicker siding patterns in widths of 8 in.

For wider sidings use two nails. Tongue and groove siding can be installed horizontally or vertically. Apply stain to cedar siding before hanging in order to achieve the most effective coating apply the oil stain to the siding before you hammer it up on your home s exterior. Align one of the vertical edges at the edge of the trim or.

Install drip edge flashing along the tops of the window and door openings. You are indeed correct about the longevity of cedar siding. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue. For vertical installations nail to horizontal furring strips.

The following recommendations are meant to minimize potential problems when wood sidings are applied over rigid foam sheathing. Of siding and cause staining buckling and damage to finish coats. For siding up to 6 inches wide use one nail one inch up from the overlap per bearing or stud. Use the piece cut off from the first layer if possible.