How To Replace An Awning Motor

Loosen the bolts holding it in place and lift it out of the housing.

How to replace an awning motor.

New motor and wind sensor. We then secured the polly cord with screws to the roller. We used the old awning as our work space to prevent scuffing or damage to the new awning. Install a new motor and tighten the bolts.

Replacing the motor on a solara power awning extend your awning about 2 feet. If this is the case unplug the motor from the electrical source. Purchase a replacement awning fabric. Measure for the correct awning replacement fabric.

This will give you room to work. We carefully unfolded located front and back and slid the new rv awning with the attached polly cord into the awning roller. Tie the awning arms off to the bracket where it attaches to the side of your rv. Use high quality heavyweight tight weave vinyl for the best results.

Afterward head to a home hardware store and purchase an appropriately sized replacement fabric. Use the manual override if the motor is completely. Loosen the awning bolts. Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer.

Install the motor by sliding it all the way into the end of the roller tube. Attach the hardware one by one. If you thought replacing your rv s main patio awning was out of your league as a do it yourselfer watch this first and you just might change your mind. Choose a fabric replacement.

Check the manufacturer s instructions for fabric recommendations. Start by measuring your awning from the inside of each cap. Unbolt the chain from the drive shaft of the awning motor. Reinstall the gear for the manual handle.

To do so measure from the center of one arm to the. Client on a budget. Do this on both ends.