How To Replace Awning Motor

Loosen the bolts holding it in place and lift it out of the housing.

How to replace awning motor.

Install the motor by sliding it all the way into the end of the roller tube. Don t pay a shop to to replace your powereed carefree of colorado rv patio awning fabric. Replace the awning on the rv with your helpers lift the arms of the awning against the rv walking the awning in slowly as someone feeds the fabric back into the channel. Use the manual override if the motor is completely.

Use high quality heavyweight tight weave vinyl for the best results. Replacing the motor on a solara power awning extend your awning about 2 feet. Pull out the motor unplug the wire plug in the new motor and reverse everything. Drill out the rivets holding the end of the cap on the end of the roller.

Client on a budget. Start by measuring your awning from the inside of each cap. This will give you room to work. Purchase a replacement awning fabric.

Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer. Attach the hardware one by one. Unbolt the chain from the drive shaft of the awning motor. Here we cut the remainder of the old awning fabric from the roller and pulled out the polly cord from the retaining track.

Replacing the rv awning. Tie the awning arms off to the bracket where it attaches to the side of your rv. Check the manufacturer s instructions for fabric recommendations. We ll show you step by step how easy it is to do it yourself.

If this is the case unplug the motor from the electrical source. Lift the roller up so it comes loose from the arm. New motor and wind sensor. Once the awning is in place make sure the lower section of the legs are locked in so you don t have to worry about it falling.

The steps to replace the rv awning are almost the opposite of the removal. You will need pop rivets reinstall the end cap. Reinstall the gear for the manual handle. Do this on both ends.