How To Use The Sunsetter Awning Lighting Remote

Press and hold the programming button see figure 14 on the back of the remote release after awning jogs.

How to use the sunsetter awning lighting remote.

Channel 1 for motor channel 2 for lights b1. We know that you will be delighted with your sunsetter awning and will experience many years of added enjoyment on your deck or patio. The active channel light will blink. Place the manual operation control bar in the manual motor crank and turn it so the awning opens about 3 feet.

The led lights will turn on for two seconds. Press the neutral middle button on the transmitter. Channel 1 for motor channel 2 for lights a1. Program the multi channel remote transmitter to the led light system use either section a b or c section a for led lights purchased with motorized oasis use steps a1 a4.

Motorized awning new multi channel remote transmitter use steps b1 b7. Set the remote transmitter to channel 1 see figure 13. For led lights purchased with motorized awning use steps a1 a4. Plug the power control box into a gfi outlet.

Channel 1 operates your oasis use channel 2 for the led lights. Press and hold the programming button see figure 14 on the back of the until the awning jogs. How to reset the remote for sunsetter motorized awnings. Set the remote transmitter to operate on channel 2 see figure 13.

If the red light does not come on at all or blinks for less than 5 seconds you will need to replace the battery see care and maintenance section on page 15. Channel 1 operates your awning use channel 2 for the led lights. Verify that the red light on the remote transmitter comes on when you press and hold the button. Push the middle button on the remote control and unplug the awning s power cord from the electrical outlet.

Allow you 18 to reach your gfi outlet and you will find your remote transmitter attached to the cord.